We usually have three options for drilling cycle selection:
1. G73 (Chip breaking cycle)
Usually used for machining holes more than 3 times the diameter of the bit, but not more than the effective edge length of the bit
2. G81 (shallow hole circulation)
It is usually used for drilling center holes, chamfering and machining holes up to 3 times the diameter of the drill bit
With the advent of internal cooling tools, this cycle is also used to drill holes in order to improve processing efficiency
3. G83 (Deep hole circulation)
Usually used for machining deep holes cnc machined
Cooling (outlet water) in machine equipped with spindle center
The cutter also supports center cooling (outlet water) cases
Choosing G81 to process holes is the best choice
The high pressure coolant will not only take away the heat generated in drilling, will be more timely lubrication cutting edge, high pressure will directly impact chip breaking of a rod, so the small chip will also be with high pressure water discharge hole in time, avoid the secondary cutting tool wear and processing quality of hole, because there is no cooling, lubrication, the problem of chip removal, So it's the safest and most efficient solution of the three drilling cycles. aluminum extrusion
The processing material is hard to break chips but other working conditions are good
The G73 is a good choice when there is no spindle center cooling (water).
This will cycle through the brief pause time or distance of the blade to realize the chip breaker, but you need a good bit of chip removal ability, more smooth chip removal tank will make scraps discharge faster, to avoid the next row of drilling crumbs intertwined, undermining the quality of the hole, using compressed air as auxiliary chip removal is also a good choice.
If the conditions are unstable, the G83 is the safest option.
Deep hole machining will be because of the drill cutting edge can't timely cooling, lubrication and wear too fast, the depth of the hole of the chip will also because relationship is difficult to discharge in time, if the chip groove chip blocking the cooling fluid, not only can greatly reduce the service life of cutter, but because the secondary cutting chip would make more rough machining hole wall, thus further cause a vicious cycle.
If the tool is raised to the reference height -R every short distance of -q, it may be suitable for machining near the bottom of the hole, but it will take a lot of time to process the first half of the hole, resulting in unnecessary waste.
Is there a better way? cnc metal machining
Here are two ways of G83 deep hole circulation
1: G83 X_ Y_ Z_ R_ Q_ F_
2: G83 X_ Y_ Z_ I_ J_ K_ R_ F_
In the first way, the Q value is a constant value, which means that the same depth is used from the top to the bottom of the hole each time. Due to the need of processing safety, the minimum value is usually selected, which also means the lowest metal removal rate, which wastes a lot of processing time virtually.
In the second method, the depth of each cut is denoted by I,J, and K:
When the top of the hole is in good working condition, we can set a larger I value to improve the processing efficiency; When the middle working condition of machining hole is general, we adopt the way of decreasing J-value gradually to ensure safety and efficiency; When the working condition is bad at the bottom of the machining hole, we set K value to ensure the safety of processing.
The second method, when used in practice, might make your drilling 50% more efficient and cost nothing!
Anebon Metal Products Limited can provide CNC Machining、Die Casting、Sheet Metal Fabrication service, please feel free to contact us.
Tel: +86-769-89802722 E-mail: info@anebon.com URL: www.anebon.com
Post time: Mar-17-2022